Gelişmiş Arama

Basit öğe kaydını göster

dc.contributor.authorHopa, Derya Yeşim
dc.contributor.authorÖzel, Emel
dc.date.accessioned2019-10-22T16:58:44Z
dc.date.available2019-10-22T16:58:44Z
dc.date.issued2016
dc.identifier.issn1300-1884
dc.identifier.issn1304-4915
dc.identifier.urihttps://hdl.handle.net/11421/21596
dc.descriptionWOS: 000378416300010en_US
dc.description.abstractPyroplastic deformation is one of the major problems of sanitaryware production, because of high temperature firing and high amount of glassy phase and this problem can be reduced by controlling of amount of glassy and crystalline phases in the microstructure. As kaolins are the finest raw materials, they are not only the major source of reactive ingredients for crystal formation but also they play a great role in homogenity of microstructure. In this work, the effect of kaolin type and amount on the pyroplastic deformation and other physical and mechanical properties of sanitaryware porcelain body were evaluated. Both weight percent and Seger formulation approaches were used to change the amounts of kaoline of new compositions. With Seger approach which allows controlling molar ratios of oxides, more successful results were obtained according to weight percent approach. The recipe D1 was produced by using Seger formulation approach with better physical properties than standard body. D1 has 12% higher casting rate, 10 degrees C lower sintering temperature and 8% lower pyroplastic deformation value than standard body. Thus, it was found out that pyroplastic deformation and physical properties of bodies can be controlled by modification of kaolin type and amount in sanitaryware body by Seger formulation. In addition, this study shows that Seger formulation can be used an alternative method to control of the product properties in ceramic industry rather than traditional weight percent approach.en_US
dc.language.isoturen_US
dc.publisherGazi University, Fac Engineering Architectureen_US
dc.rightsinfo:eu-repo/semantics/closedAccessen_US
dc.subjectSanitaryware Porcelainen_US
dc.subjectKaolineen_US
dc.subjectPyroplastic Deformationen_US
dc.titleEffect of Kaolin Type on Pyroplastic Deformation of Sanitaryware Porcelain Bodyen_US
dc.typearticleen_US
dc.relation.journalJournal of the Faculty of Engineering and Architecture of Gazi Universityen_US
dc.contributor.departmentAnadolu Üniversitesi, Mühendislik Fakültesi, Malzeme Bilimi ve Mühendisliği Bölümüen_US
dc.identifier.volume31en_US
dc.identifier.issue2en_US
dc.identifier.startpage313en_US
dc.identifier.endpage322en_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US


Bu öğenin dosyaları:

DosyalarBoyutBiçimGöster

Bu öğe ile ilişkili dosya yok.

Bu öğe aşağıdaki koleksiyon(lar)da görünmektedir.

Basit öğe kaydını göster