| dc.contributor.author | Çolak, Oğuz | |
| dc.contributor.author | Sunar, Talha | |
| dc.contributor.editor | Davies, MA | |
| dc.contributor.editor | MSaoubi, R | |
| dc.date.accessioned | 2019-10-21T21:12:25Z | |
| dc.date.available | 2019-10-21T21:12:25Z | |
| dc.date.issued | 2016 | |
| dc.identifier.issn | 2212-8271 | |
| dc.identifier.uri | https://dx.doi.org/10.1016/j.procir.2016.03.091 | |
| dc.identifier.uri | https://hdl.handle.net/11421/21369 | |
| dc.description | 3rd CIRP Conference on Surface Integrity -- JUN 08-10, 2016 -- Charlotte, NC | en_US |
| dc.description | WOS: 000417326500019 | en_US |
| dc.description.abstract | This paper provides a study on the milling of carbon fiber reinforced laminated composites. A set of milling experiments were carried out under various conditions. Cutting force results were measured and analyzed (based on the cutting coefficients modelling). 3D surface topographies of machined areas were measured. The cutting forces and surface roughness results were analyzed and better average surface roughness values were obtained from the process conditions of high cutting velocity and low feed rate. The influences of fiber orientation on the surface quality were evaluated. The tool flank wear was measured by an optic microscope periodically and the results were interpreted. | en_US |
| dc.description.sponsorship | CIRP | en_US |
| dc.description.sponsorship | Scientific Research Council of Suleyman Demirel University [4003-YL114]; SECOTOOLS company; Afyon Kocatepe UNIVERSITY company; TAI-TUSAS A.S. company | en_US |
| dc.description.sponsorship | This study was supported by The Scientific Research Council of Suleyman Demirel University (Grand Number: 4003-YL114). The authors also would like to thank SECOTOOLS, Afyon Kocatepe UNIVERSITY and TAI-TUSAS A.S. companies for their support to this study. | en_US |
| dc.language.iso | eng | en_US |
| dc.publisher | Elsevier Science BV | en_US |
| dc.relation.ispartofseries | Procedia CIRP | |
| dc.relation.isversionof | 10.1016/j.procir.2016.03.091 | en_US |
| dc.rights | info:eu-repo/semantics/openAccess | en_US |
| dc.subject | Cfrp Machining | en_US |
| dc.subject | Cutting Force | en_US |
| dc.subject | Surface Roughness | en_US |
| dc.title | Cutting Forces and 3D Surface Analysis of CFRP Milling with PCD Cutting Tools | en_US |
| dc.type | conferenceObject | en_US |
| dc.relation.journal | 3rd Cirp Conference On Surface Integrity | en_US |
| dc.contributor.department | Anadolu Üniversitesi, Mühendislik Fakültesi, Makine Mühendisliği Bölümü | en_US |
| dc.identifier.volume | 45 | en_US |
| dc.identifier.startpage | 75 | en_US |
| dc.identifier.endpage | 78 | en_US |
| dc.relation.publicationcategory | Konferans Öğesi - Uluslararası - Kurum Öğretim Elemanı | en_US |
