Ara
Toplam kayıt 2210, listelenen: 2121-2130
Lanthanum titanate (La2Ti2O7) as an interphase material in alumina (Al2O3) based composites
(Trans Tech Publications LTD, 2004)
The aim of this research is to fabricate and characterize alumina (Al2O3) / lanthanum titanate (La2Ti2O7) laminate ceramic composites. The interfacial bond between oxide laminates has a critical effect on the final mechanical ...
Pressureless sintering of Al2O3-TiCN composites
(Trans Tech Publications LTD, 2004)
A composition of 70 wt % Al2O3 + 30 wt % TiCN was prepared and pressureless-sintered at temperatures ranging from 1700 to 1840degreesC. In order to achieve densification, a powder bed was also employed. The resultant ...
Interactions Between AlN and SiAlON Ceramics
(Trans Tech Publications LTD, 2009)
In the present study, interactions between AlN and SiAlON laminated couples were investigated after gas pressure (GPS) and spark plasma sintering (SPS) by scanning electron microscopy (SEM) and energy dispersive x-ray ...
Investigation of borax waste behaviour in tile production
(Elsevier Sci LTD, 2007)
Although there are various studies published in the relevant literature on the use of borates in tile production, borax waste has been mainly used in place of feldspar and the results showed that borate migration to the ...
Utilizing of Borax solid wastes in roof tile and brick bodies
(2006)
Boron minerals are widely employed in various fields such as ceramic, glass, cement, metallurgy, etc. Although boron deposits of the world are limited, the production level of boron-based products is continuously increased. ...
Evaluation of a natural stone with fluxing capability in stoneware glazes
(Trans Tech Publications LTD, 2004)
New glaze systems have been continuously developed in order to supply certain advantages to ceramic bodies such as resistance against external thermal and mechanical forces and an aesthetic appearance as well as hygiene. ...
Mechanical properties and thermal shock behaviour of model MgO-MgAl 2O4 spinel composite refractories
(2006)
The effects of varying the amounts (5 to 30 wt%) and particle sizes of magnesium aluminate spinel (i.e. preformed and in-situ formed) incorporated in a fully dense MgO, were investigated. Mechanical properties were measured ...
Designing compressive properties of titanium foams
(Springer, 2009)
Titanium foams were produced by optimizing a relatively cheap method, sintering under flowing high purity argon gas with fugitive space holder. Removal of the space holder was conducted by dissolution in hot deionized water ...
Tailoring the Q of cymbal transducer
(Trans Tech Publications LTD, 2004)
In general high Q is a desired property for transducer applications, which is the indication low loss. However for the underwater acoustic applications wide bandwidth is also a desired property. Therefore the Q values ...
LPG sensing characteristics of electrospray deposited SnO2 nanoparticles
(Elsevier Science BV, 2014)
In this study, SnO2 films were fabricated on conductive substrate such as aluminum and platinum coated alumina using electro-spray deposition (ESD) method for gas sensor applications. Solution flow rate, coating time, ...